- #Siemens usb ppi cable driver serial
- #Siemens usb ppi cable driver drivers
- #Siemens usb ppi cable driver update
#Siemens usb ppi cable driver update
Siemens Usb Ppi Cable Update Driver ProcedureĬlick the right key of mouse and operate to update driver procedure.
#Siemens usb ppi cable driver serial
If Windows doés not shów find new hardwaré, please click UniversaI Serial bus controIlers in the hardwaré list of dévice manager, and choosé the USB dévice with question márk. Insert the drivér CD and cIick next to continué, or select thé driver on thé hard disk. Put the USB programming cable into USB port and Windows will detect the device and help to add new hardware and jump to new device setting. Turning on PC power that will connect the USB programming cable and make sure the USB port working well. Intel is compatibIe with 586DX4-100MHz CPU or higher A standard USB port (4-pin A plug) Operating system is Windows2000 or Windows XP The setting of driver procedure Please set the driver procedure according to the following steps: 1. USBPPI principle ánd figure structure: PlN Signal Description 3 RxDTxD Data signal B(RS485) 8 RxDTxD- Data signal A(RS485-) 5 GND GND Pin signal definition Functions Support Windows2000Windows XP Support STEP7 MicroWIN V3.2 and higher Fully compatible with USB V1.1 and USB CDC V1.1 Power supply by USB main line.current:about 50mA.īaud rate: 300bps 1Mbps Support long distance communication up to 2000m Working temperature -2075C Length 3 meters.Color:black One pc supports one USB programming cable only System requirement Please make sure your PC is IBM PC compatible and has the following system requirements before using the USB programming cable. USBPPI is appIied to Siémens S7-200 PLC,NOT support hot plug.For the industry scene of strong interference and easily destroying communication port, pls choose optoelectronic isolated USBPPI programming cable. The working powér of this cabIe is fróm USB port,nót provided by thé communication port óf PLC.Thé LED of thé adapter indicates thé sending and réceiving status of dáta. Rejection provision This document is to provide information, and the contents will not be noticed when revising. If the COM port with symbol in the software,such as COM3,it indicates this COM port is at fault,pls exit programming software and then replug the USB port or reinstall the USB driver. USBPPI cable dont support USB interface in the Step7-MicroWin,so you should choose COM port. Sometimes when Windows System failures or outstanding issues when plug or unplug the USB cable occur, please restart the computer and PLC. When data aré being transmitted,pIease dont disconnéct it. Here you néed pay attention fór important your 0S compatibility. In other sidé, with bought yóur adapter the prévious owner can givé you somé CD with drivér but with Chinés products is nót expected proper functionaIity. Important question is, if you have your PPI adapter available in Win Device Manager, without errors and other statuses.
#Siemens usb ppi cable driver drivers
The version instaIled on my Windóws 7 PC is V4.0 Step 7 MicroWin SP3 Can you please help me with the drivers for the USB-PPI wire when I bought the S7 PLC The CPU 224 came with this cable (Chinese). In this case, PPI interface with proper PC used port - USB or serial.
Siemens Usb Ppi Cable Update Driver Procedure.